What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 14:19

[image of Common-mode choke]
The other is “what does a “fuse” do?”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What do flat earthers think about Antarctica?
He then describes Rainy Season and Lightning.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
the problem then depends on "how fast does the fuse operate?".
OpenAI signs surprise deal with Google Cloud despite fierce AI rivalry - Ars Technica
There are two important concepts here.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
eight
How does it feel to be in a marriage without any love?
Here is a simplified AC power diagram.
The bolt then partially travels down the line to your home.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Why didn’t Obito confront Kakashi after he witnessed him kill Rin?
This is 'the assistant's answer'
nine
There are three different concepts here that are getting confused.
NHL Draft: Flyers take strong winger Porter Martone at sixth overall - PhillyVoice
but I think this circuit , shows a few more pieces.
It seems Mohan does not understand the difference between a comment and an Answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
First Sentence:
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What did your mother say that made your jaw drop?
what exactly is a ‘surge’ protector?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
After trying to buy Ilya Sutskever’s $32B AI startup, Meta looks to hire its CEO - TechCrunch
2024–10–16 [ OO OLAOYE OYEBODE ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Edit 2024–10.
Why is my crush beautiful to me but not to others?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Now when you have a certain ac resistance, then a current flows in a loop.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
I post the exact comment here.
An AC voltage/ current source, and an ac inductive load.
At least they know the answer if they wanted it.
(Dc diagram shown, AC is similar).
At one ohm, the resistor has a maximum of 1 watt power.
This is where the MOV conducts again, and dissipated the energy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This device then solves the entire problem.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
A circuit breaker is similar, but is resettable.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
These are simplified answers to the original question, and does not change anything I wrote above.
The third is lightning and “how it gets conducted into a home.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
a photo is worth a thousand words.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
One
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
This is where this question deviates from being a 'generic' question, and becomes more specific.
But… the neutral is now “floating” because of the 1 ohm resistance.
One is “what exactly is in a ‘surge protector’ ? ”
Upvotes:
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
What does a fuse do?
Because the load is inductive, the current lags the voltage.(by a bit).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
but this device (an Inductor) … impedes the rapid changes in the current.
so, what happens?
[old diagram got deleted by accident]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
In schematic diagrams this is the symbol for a fuse:
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
For this case there are devices called Metal oxide varistors (MOV).
A fuse is a non-resetable over current circuit protector.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What is lightning?
He then describes the function of a fuse.
He then asserts :
2024–10–10[John johnson John Johnson ]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This one hit behind the barn.